Loading... Please wait...
Fiber optic patch cord,Fiber optic patch panel,Fiber optic pigtail, since 2001 from China

Our Newsletter


Six types of network cable cabling standards in network cabling

Posted on 30th Oct 2019 @ 10:26 PM

With the advent of the all-optical network era, integrated wiring has become a hot topic of concern to everyone. Many high-tech wiring technologies have been put into practice. Due to the huge demand and appropriate price, it has formed a certain influence in the market.

Integrated wiring products, copper is still the mainstream, super five, six twisted pair, the performance is more suitable for people's needs, the application range is very wide. According to the on-site statistics of weak current wiring, Category 5 and Super Category 5 lines currently occupy the largest market share, but the Category 6 wire and cable maintains a growth trend, while the data of Category 5 and Category 6 network lines occupy most of the wholesale network of Guangzhou. Even more than 80%, according to this trend in the wholesale network cable industry in Guangdong, the five-line will temporarily maintain market share, and six categories, the future will gradually spread to the general mass market to meet the needs of faster network transmission.

Then, it is possible to achieve simultaneous construction in six types, in the construction and installation of the network cable, and the performance requirements of the network cable on the premise of six types of standard installations, the following are several factors to be noted to be installed.

1.Pulling force: Cable wiring construction, cable force has a certain limit, generally about 9 kg. The cable to the ground breaks the symmetrical tension.

2.Joint: The cable connector should not run longer than 2cm. Over time will cause large near-end crosstalk.

3.Protective layer: In the joint, it needs to be pressed together in the outer protective layer of the cable and not outside the joint. When the cable is subjected to an external force, the force will be on the main part of the cable and the metal parts of the connector.

4.Multiple lines: If there are two cables between the terminals, the excess cable should be cut according to the required length, and should not be rolled up and tied up.

5.Line: Because the diameter of the six cables exceeds the general Category 5 line to avoid cable winding (especially in the elbow), the diameter of the filling must be noted in the design of the pipe. Generally, the diameter of the 20 mm line pipe should be six or two.

All of the above, seemingly small problems, small details, but high-performance cables are these errors, these errors, the installation details of the six-category wire mesh effect are more sensitive, according to the standard construction, attention to detail, will create a more efficient and integrated wiring system.